I run it on my E-Slate, but that runs full windows 7. Haven't seen it available for android

Whoa, don't know what happened there Must have accidently multiplied by 2 somehow. Advance at WOT was only 32 degrees. Will load the standard 12p APNX again and see how it goes and tune again with the NVRAM from there.

Here it is. Should be able to do a bit more logging on the weekend

Thanks guys, NVRAM was in the car, but just realised knock logging wasn't enabled. Here is one of the log taken a few days ago. Have had another look, and couldnt see any knock retard. Just after a minute into the log is a particular example of it happening

Hi guys, Just started having a play with a mates vn v6. Burnt a $12P APNX memcal with a few small changes to the spark and VE table and took it for a test drive. It gives a bit of a cough if you put your foot down from 0% to anything over sort of half throttle. Watching the dash, the spark advance r...

All good got it sorted now. One of the legs of the eprom wasn't making a connection where but when i plugged the original prom in the legs are slightly longer and would connect fine. Its weird that its only one leg of the socket - but all sorted now. Thanks for the help.

Cheers

OK guys still having drama's have tried unsuccessfully burning the ARBP bin and even the standard BAAM bin I read off the memcal onto an eeprom still cant get it to work. The ARBP BAAM bins I write at 0x4000 but still no good. Any suggestions? Have tried 3 different chips

The chip I am burning to is a 29c256 - and I am burning 12p bin - 32k right so I just burn at 0000? I think the offset is not the problem, is there anything else I could be missing?

Hey guys, having a few problems burning to eprom. Finally got a burner and added a socket to a memcal. Have tried burning even standard 12P bins, but each time it just goes into limp mode. Can put the standard eprom into the socket and it works fine. Just hoping there might be something simple I mig...

Thanks mate, spotted that in another thread.

Cheers