Sorry it's been a while guys the workshop has been busy & haven't had time to post! But Doctor bob I don't know how to do that, can you do that in kalmaker, but I think that side of it is ok, as when I look at codes in kalmaker it has CLR beside all so I think it's just a comm error! But Delcowi...

DelcoWIz do you ever sleep 1 of your post's was at 4am No I don't have a chip burner yet so I can't try another tune, but it's supposed to be on it's way! Yeh no I put my own t.p.s on & IAC & in the view screen yeah it's fine at 0% Next option can I just go open loop at closed throttle easil...

BY The Way, I loaded the SPK:IPS:MAXADV to 0 degrees & it made didley squat difference so it's back to the drawing board! It goes from desired RPM 800 to around 1400 & sometime when going up down it gets worse & goes out of control & stalls, while this is happening the spark advance ...

I was told by Alan Gibbs at KalMaker, who runs the selling side of it not actually developing it, that the realtime boxes are the same, But I will confirm it with him as I told him what I wanted it for! & mentioned they have the same controls & features.

I will try that, but i'm sure I've gone to that before when I'm plugged in & it just shows me brief description of all sensor load points, like gauge screen but just all in writing & things like crank time, run time, veh speed, eng speed & so on, as I said I'll try it 2morro when i'm plu...

Engine Light Issue, I don't know what other things to mask! :?: I've masked all the trans controls that I can see, but no one will tell me how to check for fault code issues through kalmaker, as when it is plugged into realtime computer my snap on scanner won't talk to it & tell me what else is ...

Sorry VL400, I just re-read & it made sense this time! I was actually trying to figure that out myself the other day, so I plugged my snap-on diagnostic into to read data to find what gear it was in but it didn't like being plugged in with real time development box! I have a feeling it's wired t...

Thanks Guys, All Handy Info I shall go checking now, as far as answers how do i wire in range selectors as it is a manual? & Yes I have the manual trans box flagged thank you, was 1 of the first things I did but I don't know why they have it if it doesn't automatically mask all of the trans vari...

Hey Delco, I had a quick look at my word documents as i'm not with the car or software at the moment & I can't seem to find anything like ISP? What does it stand for, one that I can find that could be like that is ISD:BAPRPM which i think is idle speed for low barometric pressure I think, So I t...

In Fact I Do know who it was released to which was the arabs, not only that I have the PCM code which I have a full release of all the GM & the PCM code is CARN, If anyone would like the lists of pcm codes with what gear they were released with let me know & I shall pass it on! I'm surprised...