There are unused inputs, look at the pin listing in the 11p zip and look for inputs without a blank description and in the overview pdf, and the description of the fields in the log definition (adx) for ones which list the pin but not purpose. Note the coltage range. Knock is special, you cant use i...

Thanks, but as above we need another developer with interest in adding slave support to go further. Its a hard one, because the code is stored in the cpu and we need to understand and create the mechenism of running code on the slave and using shared memory to get the payload in to the slave's stora...

No. Mine arrived but appears to be dead on arrival, and there has not been much interest in it, or few posts about it. As above you can tune the calibration in a bin, but at this stage pcmhammer support for the slave cpu is unlikely to be developed without another developer coming aboard who wants t...

Exactly right. Regarding the tactrix, its not so much pcmhammer doesnt support the tool, its that the tool doesnkt support the pcm's vpw protocol. Regarding the mongoose, I read there are clones of the JLT out there, its not clear if this is a bad clone or a problem with the JLT not supporting vpw. ...

eventually, yes. 8-10 years is a long time. Its such a pitty electronics shops that do this sort of stuff are so rare now.

You probably want to get idle in the ballpark first so you can sit there in the car looking at your laptop without it stalling. How you get the idle in might depend on calibrating any hardware you change, MAF, injectors, etc rather than idle tables. Then I'd do AFR, if the spark seemed sain and not ...

If it's a '424 and you are putting 11P on the standard memcal it'll fit. But they're very old and they don't have electronic erase. So you need to get a UV eraser and pull the sticker off the chip and erase it with UV light. Most people replace the chip with an electronic erase version, and make up ...

You pull the nvram off the assembly and put it direct in the programmer. use a small flathead screw driver and lift it up a little at one end, then the other, then back to the first and so on and be careful not to bend the opposite corner leg when it comes off. when re-installing go gentle and make ...

Cool, thanks

Maybe. There are people that run both computers from both generations in parallel, so consider that might be the case too.