| bellett.net http://delcohacking.net/forums/ |
|
| Röbot's Wasp http://delcohacking.net/forums/viewtopic.php?f=13&t=2693 |
Page 1 of 1 |
| Author: | robot__ [ Fri Apr 18, 2014 5:26 am ] |
| Post subject: | Röbot's Wasp |
Hello all *waves* For those that don't know me my name is Rowena aka Robot from WA and I have just purchased my very first Isuzu Wasp. Had a little scratch around on the little beast today and I take it one of these is the chassis number? Top number is 319534 and the number at the bottom is 8007788 
|
|
| Author: | robot__ [ Fri Apr 18, 2014 5:45 am ] |
| Post subject: | Re: Röbot's Wasp |
More photos of my Wasp            
|
|
| Author: | robot__ [ Fri Apr 18, 2014 5:54 am ] |
| Post subject: | Thermostat... or lack there of :P |
What the... Where's the thermostat?  
|
|
| Author: | PR91 [ Fri Apr 18, 2014 7:23 am ] |
| Post subject: | Re: Röbot's Wasp |
Hi. 314 number is the engine number. Is stamped in the block on the drivers side on the flat face just near the distributor. Will have 'G150' as a prefix. 800 number is the chassis number. Is stamped in the chassis on the front face of the crossmember that goes between the rails under the rear of the cab/seat area, on the passenger side. |
|
| Author: | robot__ [ Fri Apr 18, 2014 1:42 pm ] |
| Post subject: | Re: Röbot's Wasp |
8007788. Where does that slot in with the other wasps out there? I saw a post with chassis numbers but wasn't sure if that's for Wasps aswell or just Belletts. |
|
| Author: | PR91 [ Sat Apr 19, 2014 12:08 am ] |
| Post subject: | Re: Röbot's Wasp |
I have a database here of both. I'll check when I get 5. |
|
| Author: | robot__ [ Sat Apr 19, 2014 4:44 am ] |
| Post subject: | Re: Röbot's Wasp |
Sweeeeet. Thanks
|
|
| Author: | rod [ Sat Apr 19, 2014 9:19 am ] |
| Post subject: | Re: Röbot's Wasp |
 wa red wood tray  only thing worth keeping
|
|
| Author: | gt orphanage [ Sat Apr 19, 2014 11:08 am ] |
| Post subject: | Re: Röbot's Wasp |
I think it is a good starting point 99% complete. Not a lot of rust if any. Go for it. |
|
| Author: | robot__ [ Sat Apr 19, 2014 1:39 pm ] |
| Post subject: | Re: Röbot's Wasp |
Why's the tray so good? I was gonna take it off and make another one. A bit less.... chunky :p |
|
| Author: | BULLITT [ Sat Apr 19, 2014 8:38 pm ] |
| Post subject: | Re: Röbot's Wasp |
mate welcome on board ...great find .....my opinion ....id leave the tray its so much the era .....check out farmers and bembokas wasps ..........great ...davo |
|
| Author: | Farmer [ Sun Apr 20, 2014 11:15 am ] |
| Post subject: | Re: Röbot's Wasp |
Hi again, Looks like your truck is 1788 units newer than my earliest one and 60 older than one at the gt orphanage. (Walter?) There are some others in a thread I've bumped in general Bellett chat. Perhaps other owners may add theirs, but not everyone wants them on display. Thats why PR91 has the private database. Cheers, Matt. |
|
| Author: | Stickman [ Mon Apr 21, 2014 8:11 am ] |
| Post subject: | Re: Röbot's Wasp |
Hiya Rowena, Stickman's the name and Donkey's the game.... I can spot ya a glovebox lid if ya want one. Just PM me delivery deets and I'll send one off for you 
|
|
| Author: | robot__ [ Mon Apr 21, 2014 9:49 am ] |
| Post subject: | Re: Röbot's Wasp |
PM sent. Thanks Stickman |
|
| Author: | Leadfoot_Liz [ Mon Apr 21, 2014 11:27 am ] |
| Post subject: | Re: Röbot's Wasp |
Couldn't ask for a nicer car to start with, But then again i have a soft spot for utes. And Walter is mine  You do what ever you want to do. It's up to your personality to shine through Can't wait to see the progress Lizzie. |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|