| bellett.net http://delcohacking.net/forums/ |
|
| Twin cam inlet manifolds http://delcohacking.net/forums/viewtopic.php?f=6&t=3230 |
Page 1 of 1 |
| Author: | Gunna [ Sun Feb 14, 2016 9:02 pm ] |
| Post subject: | Twin cam inlet manifolds |
I want to buy a set of inlet manifolds for the G200w twin cam motor. New, old or replica doesn't matter. Anyone? |
|
| Author: | Glenn [ Sun Feb 14, 2016 10:21 pm ] |
| Post subject: | Re: Twin cam inlet manifolds |
Gunna wrote: I want to buy a set of inlet manifolds for the G200w twin cam motor. New, old or replica doesn't matter. Anyone? Maybe what type though Dean? Webers, SU's ? anything? I have no idea if this might work but in the spare Sport, there is a inlet manifold on the floor.... maybe can be modded. |
|
| Author: | Gunna [ Sun Feb 14, 2016 11:05 pm ] |
| Post subject: | Re: Twin cam inlet manifolds |
Glenn wrote: Gunna wrote: I want to buy a set of inlet manifolds for the G200w twin cam motor. New, old or replica doesn't matter. Anyone? Maybe what type though Dean? Webers, SU's ? anything? I have no idea if this might work but in the spare Sport, there is a inlet manifold on the floor.... maybe can be modded. The plan is to trial the replica webers which are sold on fleabay but I need a set of manifolds to suit. Thx Glenn, I'll dig around the SS (Spare Sport) when I finally get it off the trailer onto hard ground. Also, Peter A found a single carby and manifold to suit the 1800 motor, so I have that option to leave in the motor in the SS. D |
|
| Author: | gt orphanage [ Sun Feb 14, 2016 11:25 pm ] |
| Post subject: | Re: Twin cam inlet manifolds |
I will see what I can do. I had a mould made of them a few years back the old bloke that did them was not well for a while. I promised Gricey I would get a set made and he reminded me on the weekend. I will see if he is up for a few sets both my twin cams are running these manifolds. |
|
| Author: | Gunna [ Sun Feb 14, 2016 11:35 pm ] |
| Post subject: | Re: Twin cam inlet manifolds |
Thx Mr. GT I'll be after 5 sets if it goes ahead. 2 for me, 2 for a friend and a spare if Wendy goes ahead we her project. D |
|
| Author: | F3ARED [ Mon Nov 14, 2016 2:53 am ] |
| Post subject: | Re: Twin cam inlet manifolds |
Did this end up going ahead? Im after a set too. Soft-mount versions are available ex-yahoo japan but arent really suitable for what i need. N- |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|