the rear panel I showed earlier is 100 euro.
Glenn, the panel is already on its way to the new owner, so no pic at this moment. There is nothing to see behind by the way, no double metal, just a hole for the bolt.
Davo, you see the pic of the rear guards? That would be a shame to cut them up for just the litlle piece below. Ari in Finland has fibre glass panels made for that special. The rubber you mention is off course a problem here too. And even if we had it a problem to ship with the alu strip in it!
groetje Dick

Are there any LH rear quarters available for a '65 PR20 sedan Dick?

This ype with the vent holes in (weld them up?) for the Sport and GT. these panels are also for the sedan / 4 door available yes.

Hi Bullit,
I have recently had windscreen rubbers ( front and rear ) made for my Wasp.
The details are. .RESTORERS HOTLINE ( RARE SPARES )
08 8354 0777
384 South rd., Richmond, SA 5033
Although they don't have the chrome strip ( not that I asked for them ) the rubbers supplied would accommodate them.
If you have a rear quarter window rubber to send them as a sample they may be able to make some up. I am sure if they were doing a run of those you would be able to get a few sets done to reduce the cost. I know I would take a set.
Warren.

do you have a picture of the rubber profile ? There are some buy by meter screen rubbers about but they mostly suit the rear sedan windows.

No. I sent down my original screen rubbers and had the new ones made to suit. No obvious joints that way.

Expensive? e="67GT"]No. I sent down my original screen rubbers and had the new ones made to suit. No obvious joints that way.[/quote]
Expensive?

Davo, just buy them off eBay!

No Glenn, it was about the same as the GT ones on e-bay, but they don't do Wasp/Sedan ones.

No luck Glenn?

I have found a prototyping house in China who can do repro's for me, just need the parts! I can get optical quality polycarbonate lenses made, which give their location, would probably be ideal. Currently getting a run of Mazda R360 interior light lenses done through the same company.

I'm very sorry but i searched the whole shed and it seems i must have given them to somebody in the BCCV as I had no real need for them on the Sport anyway..
There maybe somebody else with a cracked one you could use as a pattern.

Naw, bummer.

HOWEVER, is anyone interested in a repro set of lights (casting, lens, brackets, the lot)? I will get some made if (a) people are seriously keen, (b) someone can give me a sample!

Any takers?

Hi Dwayne,
Which model of GT are we talking about for the lights ?

66 - 68 PR91 if it's for his own car.

^ Wot he sed.

I'm talking about the front driving lights of a PR91...they're always missing and mine is no exception unfortunately.

Ok,
I would be interested in those too then Dwayne, if you are getting them made.

Well, mine doesn't have any either, so I'd be curious what it would cost. I don't mind the clean look without them, but in the intrests of originality, I'd consider.
Cheers, Matt.

I can model up and reverse engineer the parts, I have a good caster and lens moulder in China I can use...I just need the bits!

Anyone got a light I can model up? This is would be $5-6k worth of work if I was charging a client, so don't look the gift horse in the mouth, I may be able to guarantee us all a lifetime supply of ultra rare driving lights!

is that the whole light or just the glass to repro ?