 |
 |
 |
|
Page 1 of 1
|
[ 4 posts ] |
|
| Author |
Message |
|
gt orphanage
Joined: Fri Mar 20, 2009 8:23 am
Posts: 1816
|
Can anybody comfirm if a head off a 5 bearing engine will fit a 3 bearing block?
|
| Thu Apr 15, 2010 8:29 am |
|
|
|
PR20 Auto
Joined: Tue Aug 11, 2009 4:05 am
Posts: 50
Car(s): 1967 Bellett Auto Sedan
|
I do know that a three bearing head will fit a five bearing block if you drill out the bolt holes (from 10mm to 12mm). I can't see why the opposite can't be true if you re-tap the block (from 10mm to 12mm).
(Some-one on this forum owns the auto sedan that has a three bearing head on it. I helped to do it. It also has one of my rear windows with it to replace the broken one it had on it when they bought it.)
_________________
PR20 Auto
|
| Fri Apr 16, 2010 12:17 am |
|
|
|
PR20 Auto
Joined: Tue Aug 11, 2009 4:05 am
Posts: 50
Car(s): 1967 Bellett Auto Sedan
|
I just thought. You could also sleeve the bolt holes, but that would leave you with the skinny little 10mm three bearing head bolts.
_________________
PR20 Auto
|
| Fri Apr 16, 2010 12:21 am |
|
|
|
gt orphanage
Joined: Fri Mar 20, 2009 8:23 am
Posts: 1816
|
thank you that helps me make the decesion at hand.
|
| Sat Apr 17, 2010 2:46 am |
|
|
|
|
Page 1 of 1
|
[ 4 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 4 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
|
|
