Looking at the last posts for $12P V1.12 it's location 0x9BB8.fad2629 wrote:Excuse me...
If I understood correctly:
in firmware 12Pv111.bin at address 0x1BB8 I need to change the value from 0x0084 to 0x0153 to get the stream "manifold fuel", and in 1bar ADX instead of "CTS Voltage" the value "manifold fuel" will be shown.
???
If you're using $12P V1.11 either update to 1.12 or use the V1.11 file VL400 posted above and then write your cal data into it. (I'm not sure but the location may change from V1.11 to V1.12)
In the ADX manifold fuel will be shown, once you edit the ADX and make the calculation for CTS voltage just X (no calculation), otherwise it will apply the CTS voltage calculation (how it converts a 0-255 data byte into a 0-5v voltage)