Page 2 of 2
Re: How to modify VT 304 Sequential V8 harness for HQ-WB
Posted: Sun Sep 03, 2023 10:12 pm
by Dylan
Cleaver wrote:
Thankyou mate for that, will be grabbing one of those plus relays after this post..
While I'm waiting for it all to arrive, do you think you could point me in the right direction with a VS3 or VT1 standalone loom pinout?
I'll should be able to dig one up. I'll have a look tomorrow.
Re: How to modify VT 304 Sequential V8 harness for HQ-WB
Posted: Mon Sep 04, 2023 10:15 am
by Cleaver
Have ordered the eaton bussman PDM, silly question as I've looked at several schematics, and I still believe I need to use 5 pin relays, as a signal output is needed to trigger other circuits.. could someone please confirm?
https://www.autoelectricalparts.com.au/ ... 12vdc.html
Re: How to modify VT 304 Sequential V8 harness for HQ-WB
Posted: Mon Sep 04, 2023 11:04 am
by Dylan
4 pin relays should be ok, 5 won't hurt anyway.
When your ordered PDM did you get the one linked above? That has bridged fuse side but NO bridge on the relay side. That's what's needed.
Re: How to modify VT 304 Sequential V8 harness for HQ-WB
Posted: Wed Sep 06, 2023 9:22 am
by Cleaver
Dylan wrote:4 pin relays should be ok, 5 won't hurt anyway.
When your ordered PDM did you get the one linked above? That has bridged fuse side but NO bridge on the relay side. That's what's needed.
Certainly did mate, Bussed fuse side only PDM..
