Yes i will look into that.antus wrote:It sounds like its loosing sync. Can you have a look at the REF signal on a scope and see if its clean?
Also also have questions about distributor ref signal , output from the camera type module. Does my signal need any conditioning before the ecm.
As i am running the rb30 dizzy ,cardboard cutout 6 slots approx 5deg wide . gives a square wave output . straight into dis ref .
I have pulled apart the 3x 18x setup, I could have looked at the output from that for dis ref sig,
After looking back over my post on page 7 there is a good diagram showing 60' high the 60' low , this is not what i have . will go back and try again.