Hi Guys
Anyone have a pinout for this ECU?
Struggling to find anything.
Need powers, grounds and communication pins.
Cheers
VZ 3.6 V6 ECU Pinout Bosch E55
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: VZ 3.6 V6 ECU Pinout Bosch E55
I'm not sure if all of them were E55 or not ? but I have this....
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Re: VZ 3.6 V6 ECU Pinout Bosch E55
Oooh, thats gold. Thanks a bundle! I'll have a peak see if it matches.
Anyone bench harnessed one for reflashing?
Anyone bench harnessed one for reflashing?
- antus
- Site Admin
- Posts: 8258
- Joined: Sat Feb 28, 2009 8:34 pm
- cars: TX Gemini 2L Twincam
TX Gemini SR20 18psi
Datsun 1200 Ute
Subaru Blitzen '06 EZ30 4th gen, 3.0R Spec B - Contact:
Re: VZ 3.6 V6 ECU Pinout Bosch E55
Made post a sticky.
Have you read the FAQ? For lots of information and links to significant threads see here: http://pcmhacking.net/forums/viewtopic.php?f=7&t=1396
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: VZ 3.6 V6 ECU Pinout Bosch E55
no I've only ever re-flashed in the car.DHW wrote:Oooh, thats gold. Thanks a bundle! I'll have a peak see if it matches.
Anyone bench harnessed one for reflashing?
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Re: VZ 3.6 V6 ECU Pinout Bosch E55
ya I made up a bench harness while ago.... worked fine. from memory, I just followed holdens pinouts and connected power, ground and CAN wires.
Re: VZ 3.6 V6 ECU Pinout Bosch E55
May need to throw in another terminating resistor into the harness to make the comms line meet standards, otherwise works straight out of the box following the diagram.Jayme wrote:ya I made up a bench harness while ago.... worked fine. from memory, I just followed holdens pinouts and connected power, ground and CAN wires.
Your Local Aussie Reverse Engineer
Contact for Software/Hardware development and Reverse Engineering
Site:https://www.envyouscustoms.com
Mob:+61406 140 726
Contact for Software/Hardware development and Reverse Engineering
Site:https://www.envyouscustoms.com
Mob:+61406 140 726