Attached is PDF's containing standard pinouts for VN-VP and VR-VS engine loom connectors for wiring conversions.
The "control" connectors are in the engine bay, and the "body" connector is located near the ECM/PCM inside the vehicle.
Ignore all the B1, B2, G3 etc markings. They are for converting the loom to use the standard VT/VX 3 plug pinout arrangement (as shown in my other post here in the wiring section)
VN-VP and VR-VS Engine Loom Connectors
-
- Posts: 471
- Joined: Thu May 03, 2012 10:50 pm
- cars: HZ One Tonner
VE Ute - Location: Castlemaine, Vic
VN-VP and VR-VS Engine Loom Connectors
- Attachments
-
- VR VS Standard Connectors.pdf
- (549.34 KiB) Downloaded 1764 times
-
- VN VP Standard Connectors.pdf
- (475.78 KiB) Downloaded 1532 times