pcmhacking.net

all i did to make it log engine and trans data was add a listen for silence command between engine and trans listen commands as for a good solid connection the best way seems to be how i have it set with the disable and enable chatter commands at both ends.now just to pluck up the courage to flash in some changes lol

Again Nice work Delco, now get some nuts & update your file & you can just do calibration & takes a minute, don't need to do full bin!

Let the flash tool do the rest of the work & click yes for update checksum & BINGO!

Cheers VX L67 Getrag

That word BINGO! is a little worrying

Used the adx for the first time today....
Nice job thanks helped heaps...

anybody using this notice that the DTC's dont seem to work correctly, ive just done logging on 3 vx/vy's and they all say the dtc 92 is active which it isn't.

This is because you told the BCM to shut up. The PCM is sending out a low speed fan request but the BCM is not responding so the code is set.
Yoda69

true that

Hey there The1, I know I am a little fish in a monsterous ocean, but I too had the same issue of the dash goin spaz on a connect, I only get that if the car is already running, if I connect first with ignition in on position then start car all goes perfectly...
I also believe that the "CHECK ENGINE" displaying on the dash is normal...

Sorry if u already knew this, just bored at work lol (feel stupid now, just noticed age of post)
***kicks self***

Hi there Guys I have Vl's usb Aldl adapter and have tried all three ADX on my VY 2 with factory Lpg. My issue is one of my O2 sensors reads all over the place and the other is rock solid. How do I confirm the Adx is mapping the right signal from the PCM. I have a Bin file i downloaded with Flash tool The mask of my bin file is AA0A was opposed to the 06a or b found on this site. If it is because of the Bin how do I locate the correct hex to map

ADX is the same for all VX-VY N/a calibrations but if you post up your bin we can tell you what version & what XDF to use to modify & to tell about o2 sensor would need to post up your XDL!