| bellett.net https://delcohacking.net/forums/ |
|
| Bellett gt hood lining https://delcohacking.net/forums/viewtopic.php?f=37&t=1971 |
Page 1 of 1 |
| Author: | Waldo [ Wed Jul 04, 2012 8:56 pm ] |
| Post subject: | Bellett gt hood lining |
Can anyone tell me what type of material is used for a stock bellett hood lining? A photo would be real handy that shows the texture |
|
| Author: | Glenn [ Wed Jul 04, 2012 10:00 pm ] |
| Post subject: | Re: Bellett gt hood lining |
not much help really except to say that the original style material was avaialble here, when i did my last GT. glenn |
|
| Author: | 1968GT [ Sat Jul 07, 2012 9:44 am ] |
| Post subject: | Re: Bellett gt hood lining |
Hey Waldo, Since I have Glenns GT he last restored, I will try to get a photo for you. I will try to get it up ASAP. Regards, Dave M. |
|
| Author: | 1968GT [ Fri Jul 27, 2012 5:22 am ] |
| Post subject: | Re: Bellett gt hood lining |
Waldo, SORRY, I have let you down with these photos, I will try to remember on Sunday as I won't be home until Sunday. I have been working on the GT repairing brakes and still I forgot, you know what it is like as you get older  Geeshh! shouldn't admit to that eh!!! I will post the photos on Sunday.  Dave M. |
|
| Author: | Glenn [ Fri Jul 27, 2012 5:59 am ] |
| Post subject: | Re: Bellett gt hood lining |
Dave re the leak you have... there's a post on here somewhere with a seal for the master cylinder to reservoir...... glenn Guys does anyone know where I can get some rubbers to fit between the master cylinder body and the reservoir. The original rubbers on my master had perished and I have tried both brass abd fibre washers, but still have a leak between the two. Would plumbing rubbers as used in toilet fittings etc work or would the brake fluid stuff them? Cause I reckon there would be a size to fit in the local plumbing supplies joint. Somebody please help turn my frown upside down Reply with quote Post Re: fitting sigma discs to bellett Try PBR kit K7308X Boot should fit |
|
| Author: | flying [ Mon Jul 30, 2012 5:14 am ] | |||
| Post subject: | Re: Bellett gt hood lining | |||
Waldo bit dirty but I beleive original
|
||||
| Author: | 1968GT [ Mon Sep 10, 2012 3:56 am ] | |||||
| Post subject: | Re: Bellett gt hood lining | |||||
WALDO, Yep I KNOW bloody SLACK, ooops sorry  , try these photos, not sure what vinyl grain you can see but these are of the material Glenn used in the roof lining in the GT I have now!There are 5 ribs, equally distanced between each bar. I hope these are of assistance of not TOO LATE!!!  Dave M.
|
||||||
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|