bellett.net
https://delcohacking.net/forums/

extractors
https://delcohacking.net/forums/viewtopic.php?f=40&t=2051		 Page 1 of 1
Author:  gt orphanage [ Tue Sep 11, 2012 6:20 am ]
Post subject:  extractors
i have a set of gt extractors here that i am sending to a workshop to have plates made for sedan cast head and gt it looks as they are both the same only the bolt pattern is different :?: Lizzies race car had a engine woops on the weekend and the new engine is ready to be fitted so i will have the plate made and make a sedan set the gt set i have can be copied.
If there is interest in the plates or a set of headers made let me know and i will get extra duplicates made i can send a sedan down to make them and bring them to the nats if i have room.
Author:  oz_toffa [ Tue Sep 11, 2012 10:48 am ]
Post subject:  Re: extractors
need anything like this as a template?

Attachments:
extractors_sedan.jpg
extractors_sedan.jpg [ 127.43 KiB | Viewed 14209 times ]
Author:  Farmer [ Tue Sep 11, 2012 11:10 am ]
Post subject:  Re: extractors
Thats interesting mate, Gary is working on the same project at the minute. It will be intersting to see what you both are able to achieve. No doubt there will be takers on this offer once they see the finished product.

Good onya,
Matt.
Author:  gt orphanage [ Tue Sep 11, 2012 11:22 am ]
Post subject:  Re: extractors
If Gary is doing them then i will bail on the project silly having two suppliers :)
Author:  Glenn [ Tue Sep 11, 2012 10:08 pm ]
Post subject:  Re: extractors
would it be worth making the plate in one piece with a thin section joining them to be cut away later. It might make the fabrication of the rest of headers easier.

glenn
Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/