| bellett.net https://delcohacking.net/forums/ |
|
| Falcon steel wheels FS Brisbane https://delcohacking.net/forums/viewtopic.php?f=7&t=356 |
Page 1 of 1 |
| Author: | BrisBellett [ Wed Mar 18, 2009 2:39 am ] |
| Post subject: | Falcon steel wheels FS Brisbane |
1 set of 4 Falcon 13" steel wheels in VG condition. Wider than the original Bellett wheels and allows use of wider tyres. Pick up in Brisbane or arrange transport. Contact me via site email. $50.00 for the set. |
|
| Author: | 1968GT [ Thu Mar 19, 2009 5:37 am ] |
| Post subject: | Re: Falcon steel wheels FS Brisbane |
They fit the Bellett don't they, I know you say wider than Bellett, I would not like to buy, then they don't fit? Are they 51/2" wide? What does the FS stand for. I have 4 Bellett wheels that need a bit of work, however if these are good as you say, I will use them on the GT with the standard dress rims. |
|
| Author: | BrisBellett [ Thu Mar 19, 2009 8:37 am ] |
| Post subject: | Re: Falcon steel wheels FS Brisbane |
Hi, there is some discussion on wheel sizes in the 'wheels, suspension' section. These are 5-1/2" steel wheels that will bolt straight on without any problems. It will allow you to use a wider tyre and increase the track width slightly. Contact me via 'email' option if you are int'd. |
|
| Author: | 1968GT [ Wed Jan 06, 2010 5:14 am ] |
| Post subject: | Falcon steel wheels FS Brisbane |
HEY Bris Bellett, did you sell these wheels? Are they 4 stud? Dave M. |
|
| Author: | BrisBellett [ Thu Jan 07, 2010 4:31 am ] |
| Post subject: | Re: Falcon steel wheels FS Brisbane |
Hi and yes they were 4 stud and no they are long gone. Clyde |
|
| Author: | 1968GT [ Thu Jan 07, 2010 9:47 pm ] |
| Post subject: | Re: Falcon steel wheels FS Brisbane |
Thanks Clyde, they are hard to find and transport may have been a problem for me. Thanks anyway. DM. |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|