Hey All,
Trying to write to nv ram for the first time on my new true usb willem & keep getting this problem;
Elapsed time: 0.12 seconds.
Write failed, Address=0x000000, Buffer=0x00 Device=0x0A
Write failed
Do I have to change the start address, file offset or device offset(straigth out of working on the bin in tuner pro 5?)
Cheers VXL67Getrag
New True Willem GQ-3x
-
- Posts: 2907
- Joined: Sun Aug 02, 2009 9:16 pm
- Location: Bayside, Melbourne, Victoria
- Contact:
- delcowizzid
- Posts: 5493
- Joined: Sat Feb 28, 2009 8:38 pm
- Location: Wellington NZ
- Contact:
Re: New True Willem GQ-3x
did you select the correct DS timekeeper chip in the settings
If Its Got Gas Or Ass Count Me In.if it cant be fixed with a hammer you have an electrical problem
-
- Posts: 2907
- Joined: Sun Aug 02, 2009 9:16 pm
- Location: Bayside, Melbourne, Victoria
- Contact:
Re: New True Willem GQ-3x
Umm, No I didn't as I don't know what that is?
There just the dallas ds1245Y, I ended up turning on the old computer & used the old programmer, but would be good to get the true usb working to save doing it!
There just the dallas ds1245Y, I ended up turning on the old computer & used the old programmer, but would be good to get the true usb working to save doing it!
-
- Posts: 2907
- Joined: Sun Aug 02, 2009 9:16 pm
- Location: Bayside, Melbourne, Victoria
- Contact:
Re: New True Willem GQ-3x
is the ds timekeeper chip just the brand & version of the chip?
If so yes I did, there's just 1 ds1245y -100, but if there's any other settings I can't find them?
It's strange that it programmed fine in my old skool memprogL ok?
I still need to figure out how to use the OSE plugin properly too, but thats for another thread & I'll have a bit more of a play too!
If so yes I did, there's just 1 ds1245y -100, but if there's any other settings I can't find them?
It's strange that it programmed fine in my old skool memprogL ok?
I still need to figure out how to use the OSE plugin properly too, but thats for another thread & I'll have a bit more of a play too!
-
- Posts: 2907
- Joined: Sun Aug 02, 2009 9:16 pm
- Location: Bayside, Melbourne, Victoria
- Contact:
Re: New True Willem GQ-3x
OK have to admit, it was user error!
My old programmer had chips go in with no.1 pin at the end opposite handle for securing so that was how I was loading them, but now I'm putting the chips in the right way it's all good!
VX L67 Getrag!
My old programmer had chips go in with no.1 pin at the end opposite handle for securing so that was how I was loading them, but now I'm putting the chips in the right way it's all good!
VX L67 Getrag!